Thank you for visiting MistHub’s Help guide to Tank Maintenance and Troubleshooting. Here we will discuss the best way to perform routine maintenance on your own tank atomizers to ensure they are functioning in top condition. We are going to also discuss some common problems as well as their solutions. First, let’s examine the best way to properly utilize a fresh tank or possibly a new coil you simply installed in your tank.

Once you use a new coil you should make certain you prime it before utilizing it. Priming a coil will make sure the wick in it is saturated with e-juice prior to its first use. This substantially lowers the potential of burning your wick or damaging your coil. To prime your coil you will want to place 4-5 drops of e-juice into the coil head. Install the coil head by threading it to the tank’s base. You could then fill and assemble your tank. For the best results you ought to wait 5-10 minutes before its first use. In case you are in a hurry and will not wait the 5-10 minutes you need to at the very least wait 1-2 minutes, close the flow of air and take several deep pulls without firing your device. You should be capable of then re-open the flow of air and make use of the tank normally without issue.

Whilst it may appear like a complex task a tank properly it really is quite easy. To start with you will want to ensure that is stays clean. At least one time a month clean your tank. Begin with treatment of coil(s) and then for any O-rings. While detaching the O-rings try to find warning signs of wear or any cracks. If your any O-rings are damaged, replace them. Clean your tank thoroughly using isopropyl alcohol or tepid to warm water as well as a mild dish soap for the lining and out. Be sure to pay special care about the threads (a classic toothbrush can help with this part). Make sure you wash your O-rings also. Rinse it away, then rinse it again simply to make sure there’s no soap or residue put aside. As soon as your wotofo is entirely dry you are ready to reassemble and use it again.
The most frequent issue tank users have to face is leaks. A leaky tank can be a real inconvenience but typically these are not too difficult to correct. Ninety nine percent of the time an aquarium is leaking because it is letting air in somewhere which breaks the vacuum that holds your e-liquid from the tank. First, take the tank apart inspecting all glass or plastic parts looking for any cracks. If you do not go to whichever, confirm the O-rings for warning signs of damage or cracks. If any of the above mentioned parts are damaged at all replace them when needed. Be sure to check and ensure the coil head is fully threaded into place however it is not overly tight. It ought to be easily removable without the use of tools. If it is too tight it may have damaged the O-ring(s) at the base from the coil or pushed them misplaced. When the O-rings on the coil are damaged replace them or even the entire coil. If your tank is constantly on the leak and all of these may be checked it can possibly be in connection with a poor coil head. Over time and through make use of the wicking materials can break up and never hold all the juice as they used to. This will cause deficiencies in surface tension allowing air to sneak up from the coil in which case it ought to be changed.
More info about wotofo check out our website: read here